I made a simple smps with uc3845. The output of the ic is connected to IRF840 and a EE30_15_7 ferrite transformer wound by me. The osc section seems to be working. Vcc supplied is 16.5 v Pin 1 connected to opto coupler pin 2 to GND Pin 3 to the 0.47ohm resister connected between Mosfet...
I'm trying to turn a Boost into a Flyback and then into an audio amplifier. Basically I wanted a simple SMPS modulated with an audio signal. I know, you will say that the class D amplifier is also an SMPS, but the class D amplifier needs at least 2 power transistors + a large...
USB Charger (and SMPS) AC Leakage Experiment To confirm my beliefs and to correct some erroneous information presented in this post My Mobile Charger Shocked Me While Charging, and other posts in this forum, I conducted an experiment. Call it put up or shut up. Belief #1 USB chargers and by...
This thread is a carry-over from one that i started earlier on a SMPS that wasn't working. The problem with that supply has been solved and is now working fine. My next project is to build a battery charger using that supply, only problem is the output is +31.5 volts DC which is far too high for...
PFC is a circuit which corrects the current and voltage phase shifts to increase efficiency and it provides 360v or 400v at its output which eliminates the line regulation for the SMPS circuit and also some PFC cancels out input harmonics/noise to improve power factor. We took television power...
hello, I was trying to build SMPS using switching ic's UC3845 or HVLED007 but ending with less current delivery or poor power factor might be due to improper flyback transformer design. the thing is i don't have the bobbin , core datasheet were i can get all the specs currently i have...
I have an SMPS set to output 12.81V (it is laptop 20V power supply), but it fluctuates between 12.2V and 12.8V at idle, which is around 6%. It stabilizes at 12.81V under a load, I tested it on 1.5A. Is this kind of fluctuation acceptable for an SMPS on idle, and could it potentially damage the...
SMPs are generally programs designed for several different populations of students 1) Those who completed their science requirements in college and need to improve their academic standings (mostly low GPA issues).
Prior to making a solid connection between the SMPS negative output terminal and "actual earth ground." I suggest measuring the voltage between those two points.
Hi, I'm searching for an example circuit to be run on LTSpice with a SMPS together with a common mode choke. The idea is to run a transient simulation in order to see the effect of this latest component on output voltage (noise reduction). Do you have anything to suggest? Thank you
